MIL-R-83283A(USAF)
5.3 Marking
5.3.1 Level A, B, C. In addition to any special marking or other identification markings required by the contract (see 6.2), each unit pack and exterior container shall be marked in accordance with MIL-STD-129 and as follows:
Rubber (silicone, cabin pressure seal, diaphragm type) Cross section and length (inches) or part number Manufacturer's name and address
Compound number, lot number
Specification MIL-R-83283A(USAF) Cure date (quarter and year)
STORE IN A COOL DRY PLACE
6. NOTES (This section contains information of a general explanatory nature that may be helpful, but is not mandatory.)
6.1 Intended use. The rubber covered by this specification is intended for use as a diaphragm type, cabin pressure seal.
6.2 Acquisition document. Acquisition documents should specify the following:
a. Title, number, and date of this specification. b. Dimensions and tolerances (see 3.3)
c. Quantity
d. Detail drawing and additional specification, if any.
e. Unit quantity of molded parts if other than specified. f. Whether first article sample is required (see 3.1).
g. Applicable levels of preservation and packing (see 5.1 and 5.2).
6.3 First article. When first article inspection is required for the silicone rubber material furnished to this specification. A copy of the first article test report shall be furnished the Wright Laboratory, Attn: WL/MLSE, Wright-Patterson AFB, OH 45433-6503. The first article test need not be repeated for new orders provided the materials and processes have not been changed and a certified statement to this effect is furnished to the procuring activity. The waiving of the first article tests will be strictly at the discretion of the procuring activity. First article tests will not be acceptable if they are more than 3 years old
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business