MIL-T-68410
5.2 Packing. Packing shall be level A, B, or C, as specified (see 6.2). Shipping containers, insofar as possible, shall contain the same number of rolls or sheets and shall be designed to enclose the contents in a snug, tight-fitting manner. The gross weight of the shipping container when packed for shipment shall not exceed approximately 200 pounds. The gross weight of fiberboard boxes, if used, shall be subjected to the weight limitation of the box specification.
5.2.1 Level A. Unless otherwise specified, for overseas packing the rolls of tape and sheet shall be packed in shipping containers conforming to PPP-B-601, overseas type, or PPP-B-621 class 2, any style. Plywood, when used, shall be type II, class 2 conforming to NN-P-530. A sealed waterproof liner shall be used in each shipping container. The liner material shall conform to PPP-B-1055. All seams and closures shall be sealed with adhesive conforming to MMM-A-260.
5.2.2 Level B. Tape and sheet shall be packed in suitable containers conforming to PPP-B-636, class domestic, RSC.
5.2.3 Level C. Tape and sheet shall be packed in a manner to ensure carrier acceptance and safe delivery at the lowest transportation cost to destination. Containers shall be in accordance with Uniform Freight Classification Rules or other carrier regulations applicable to the mode of transportation.
5.3 Marking of shipments. In addition to any special marking required by the contract or order, unit packages, intermediate package and shipping containers shall be marked in accordance with MIL-STD-129. The date of manufacture shall be marked by quarter and year (example 3Q91). The PIN number shall also be marked.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Intended use. The tape and sheet are intended for use as a seal and packing for the installation of glass or acrylic plastic windshields, panels and windows in cabins and cockpit of aircraft.
6.2 Acquisition requirements. Acquisition requirements documents should specify:
a. Title, number, and date of this specification
b. Issue of DoDISS to be cited in the solicitation and, if required, the specific issue fo the individual documents referenced (see 2.1 and 2.2)
c. Data requirements (see 3.2)
d. Width, thickness, and number of rolls or sheet (see 3.4)
e. Part or identification number (PIN)
f. Level of preservation, packaging, and packing required (see 5.1). g. Special markings, if required (see 5.3)
6.3 Part or identifying number (PIN). The PIN to be used for tape and sheet acquired to this specification are created as follows:
M 6841 - X - XX
| | | | Item number see Table II or III, Tape/sheet
| | |
| | | Thickness, see Table I.
| |
| | Specification number
|
| M Prefix
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business