S BY SAE-AMS-T-6841

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13

MIL-T-68410

TABLE VIII. Defects in dimensions

Examine

Defect

Tape width

Sheet width

Various by more than the plus or minus tolerances specified in table I.

Varies by more than +1/8 inch from size specified in 3.4.

and width

4.3.3.4 Examination for length per roll. The sample unit for this examination shall be 1 roll. The index level for this examination shall be 4.0 defects per 100 units. The sample size shall be based on level S-2 of MIL-STD-105. The length per roll shall not vary by more than the plus or minus tolerance from the length specified.

4.3.4 Examination of preparation for delivery. An examination shall be made to determine that packaging, packing, and markings comply with section 5 of this specification. The sample unit for this examination shall be one shipping container fully packed, selected just prior to the closing operations. Defects of closure listed herein shall be examined on shipping containers fully prepared for delivery. The lot size shall be the number of shipping containers in the end item inspection lots. The inspection level shall be S-2 and the index level shall be 4.0 defects of 100 units and shall conform to the requirements of table IX.

TABLE IX. Preparation for delivery

Examine

Defect

Packaging

Rolls

Sheets

Packing

Weight

Markings

Not the level specified; not in accordance with contract requirements.

Packaging material not as specified, closures not accomplished

by specified or required methods or materials.

Not individually wrapped and sealed as specified.

Paper interleaves omitted or not extending over full contact

area between sheets.

Not evenly or neatly stacked; stacks exceed 10 inches in height. Not level specified, not in accordance with contract requirements.

Linear material (as applicable) omitted, damaged or not as

specified.

Container not as specified, closures not accomplished by specified

or required methods or materials.

Any nonconforming component; component missing, damaged or otherwise defective affecting serviceability.

Inadequate application of components, such as incomplete closures

of case liners, container flaps, loose or inadequate strapping, bulged or distorted containers.

Gross or net weight exceeds specified requirements.

Interior or exterior markings (as applicable) omitted, illegible,

incorrect, incomplete, or not in accordance with contract requirements.